Perimeter Measurement

1. Go to Measure > Perimeter or press SHIFT+ALT+P. The Perimeter measurement mode is engaged.
2. In the Measurements section of the Measurements tab, the Depth field becomes active. This allows for the additional calculation of Wall Area on the Markups list, if desired. Enter the desired value and select the units of measure from the associated menu.

3. Click on each point of the desired shape.

4. To "close" the shape, click the first point again.

   Note: Even though their start and end points can touch, Perimeters are always considered open shapes and will behave as such. For a closed shape measurement, see Area Measurement.

5. To complete the shape without "closing" it, double-click when placing the last point.

Tips:

• Hold down SHIFT to draw lines that are at horizontal, vertical, or 45° angles.

• Click and drag to place a rectangular shape.
  • Holding down SHIFT while doing so will force the rectangle into a square.

Select a markup to reveal its control handles. Each handle controls a different aspect of the markup's size and orientation.

To rotate the markup, click and drag the orange handle outside the markup (when the markup is first placed, it will be at the top). By default, the markup is rotated in increments of 15°; to rotate in increments of 1°, hold down SHIFT while dragging.

The rotation can also be entered in the Rotation field found in the Layout section of the Properties tab.

To rotate the caption, click and drag the orange handle directly over it. By default, the markup is rotated in increments of 15°; to rotate in increments of 1°, hold down SHIFT while dragging.To return a rotated caption to its original position, right-click it and select Reset Caption Position.

To move the entire markup together, click and drag a part of it other than the control handles.

To resize a line or change its angle, click and drag the appropriate yellow handle.

To scale the markup up or down, click and drag the appropriate purple handle.

See Editing Markups for more information.

The appearance of the Perimeter measurement is configurable, including line color, style, width, and opacity, as well as the font style of the caption and whether or not to show it.

To change the appearance of a Perimeter measurement, select it and click the Properties tab.

Appearance Properties

Color: Sets the line color.

Fill Color: Controls the fill color of the endpoints.

Highlight: Makes the fill color and line transparent so underlying content shows through.

Opacity: Sets opacity level of the line and endpoints, from 0 (invisible) to 100 (opaque).

Line Width: Sets the line thickness in points.

Style: Determines the pattern of the line segment.

Show Caption: Select to include the caption text on the markup.

Show All Measurements: Select to include all measurements applicable to the markup, not just the default measurement.

Font Size: Sets the size of the font.

Text Color: Sets the color of text.

Font Style: These settings control the formatting of the text. Options include Bold, Italic, Underline, and Strikethrough. Generally, any combination of these styles can be applied to format the text.